Does It All

product photo

Does It All - DAC 108…..Broad Based Cleaner/ Degreaser cleans grime from dirty cartridges, takes case lubricant off brass after loading. Helps accelerate the polishing process for brass when sprayed on cartridge casings prior to putting into polishing media. Removes Die Lube. Also can be used when cutting rifle chambers for cleaning and inspection.

The Happy Employee Degreaser

• Low VOCs Make this a Good Choice for Environments
  Where Ventilation is a Concern

• Rapid Cleaning Capabilities to Remove Overnight Rust Inhibitors

• Good Degreaser to Accomodate Cleaning of Brakes
  & Engine Blocks Prior to Assembly

• Rapid Evaporation Eliminates Bleeding Out of Ejectors, Lifters or Cams

• All Position Spray Tip

• USDA Accepted
Finally a product perfectly designed to degrease anything you can think of! YOU NAME IT, IT DOES IT! The number one choice for plastic molders. This unique formula will cut through anything. It's rapid cleaning capabilities are pure enough to be used as a bench maintenance product and strong enough to remove most adhesives.
 
The cleaning capabilities of Does It All Degreaser are shown above.

This solvent based degreaser lifts oils from the pores of metal. Oils are then dispersed & evaporated off, leaving a completely clean surface.

Does It All will leave no residue.

This degreaser also has low VOC characteristics.

Eliminate any worry of penetrating back into the slides, cams or ejector pins.

Stop contamination marks and oil droplets from appearing on molded parts with Does It All degrease
 		  
Another degreaser out on the market shows, above, the problems molders encounter with ineffective degreasers:

The pooled degreaser was not able to remove the oils.

Wiping away the pooled areas smears the oils back into the fine pores of the metal surface.

This surface is not cleaned, and is not beneficial to molding. Pooled up degreaser and oils are going to penetrate back into slides, cams and ejector pins. Lubrication will break down. This will lead to bleeding, premature tool failure, oil droplets and oil marks.